H3C Technologies H3C S3100 Series Switches - Manual (Page 43)

2-11
Operation Command Description
Configure to authenticate users
locally or remotely
authentication-mode
scheme
[ command-
authorization ]
Required
The specified AAA scheme determines
whether to authenticate users locally or
remotely.
By default, users logging in through the
Console port (AUX user interface) are not
authenticated.
Set the baud
rate
speed speed-value
Optional
The default baud rate of the AUX port
(also the Console port) is 9,600 bps.
Set the check
mode
parity { even | none | odd }
Optional
By default, the check mode of a Console
port is set to none, that is, no check bit.
Set the stop bits stopbits { 1 | 1.5 | 2 }
Optional
The default stop bits of a Console port is 1.
Configure the
Console port
Set the data bits databits { 7 | 8 }
Optional
The default data bits of a Console port is 8.
Configure the command level
available to users logging into the
user interface
user privilege level level
Optional
By default, commands of level 3 are
available to users logging into the AUX
user interface.
Make terminal services available
to the user interface
shell
Optional
By default, terminal services are available
in all user interfaces.
Set the maximum number of lines
the screen can contain screen-length
screen-length
Optional
By default, the screen can contain up to 24
lines.
You can use the screen-length 0
command to disable the function to
display information in pages.
Set history command buffer size
history-command
max-size value
Optional
The default history command buffer size is
10. That is, a history command buffer can
store up to 10 commands by default.
Set the timeout time for the user
interface idle-timeout minutes
[ seconds ]
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10 minutes,
the connection to a user interface is
terminated if no operation is performed in
the user interface within 10 minutes.
You can use the idle-timeout 0 command
to disable the timeout function.
Note that if you configure to authenticate the users in the scheme mode, the command level available to
users logging into a switch depends on the command level specified in the service-type terminal
[ level level ] command.