Configuring vlan marking, Configuration prerequisites, Configuration procedure – H3C Technologies H3C S3100 Series Switches User Manual
Page 603: Configuring queue scheduling
1-24
2) Method
II
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-redirect vlan 2 inbound ip-group 2000 interface Ethernet1/0/7
Configuring VLAN Marking
Configuration prerequisites
z
The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual
for information about defining ACL rules.
z
The port where VLAN marking is to be configured is determined.
z
The target VLAN ID, that is, the VLAN ID to be set for traffic, is determined.
Configuration procedure
Table 1-28 Configure VLAN marking
Operation
Command
Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type interface-number
—
Configure VLAN
marking to change the
VLAN ID carried in the
incoming traffic
matching a specific ACL
rule to the specified
VLAN ID
traffic-remark-vlanid inbound acl-rule
remark-vlan remark-vlanid
Required
By default, VLAN marking
is not configured.
VLAN marking is mutually exclusive with VLAN mapping.
Configuring Queue Scheduling
Refer to section
for information about queue scheduling.
Configuration prerequisites
The algorithm for queue scheduling to be used and the related parameters are determined.
Configuration procedure
Table 1-29 Configure queue scheduling
Operation
Command
Description
Enter system view
system-view
—