H3C Technologies H3C S3100 Series Switches - Manual (Page 657)

2-22
z A cluster is established, and you can manage the member devices through the management
device.
2) Configuration procedure
Perform the following operations on the management device to synchronize local user configurations:
To do… Use the command… Remarks
Enter system view system-view —
Enter cluster view cluster —
Create a public local user
cluster-local-user username
passward { cipher | simple }
passwardstring
Required
Not configured by default.
z Perform the above operations on the management device of the cluster.
z Creating a public local user is equal to executing these configurations on both the management
device and the member devices (refer to the AAA Operation part in this manual), and these
configurations will be saved to the configuration files of the management device and the member
devices.
z The public local user configurations cannot be synchronized to the devices that are on the cluster
blacklist.
z If a member device leaves the cluster, the public local user configurations will not be removed.
Displaying and Maintaining Cluster Configuration
Operation Command Description
Display all NDP configuration and running
information (including the interval to send
NDP packets, the holdtime, and all
neighbors discovered)
display ndp
Display NDP configuration and running
information on specified ports (including
the neighbors discovered by NDP on the
ports)
display ndp interface port-list
Display global NTDP information display ntdp
Display device information collected by
NTDP display ntdp device-list
[ verbose ]
Display status and statistics information
about the cluster
display cluster
Display information about the candidate
devices of the cluster
display cluster candidates
[ mac-address H-H-H |
verbose ]
Display information about the member
devices of the cluster display cluster members
[ member-number | verbose ]
You can execute
the display
command in any
view.