H3C Technologies H3C MSR 50 - Manual (Page 108)

3-4
z
Auto-sensing at a rate of 10 Mbps or 100 Mbps.
z
Full duplex and half duplex, of which full duplex is common.
Interface attributes
Table 3-4 Interface attributes of XMIM-16FSW/XMIM-24FSW
Attributes XMIM-16FSW/XMIM-24FSW
Connector type RJ-45
Interface type MDI/MDIX
Number of connectors 16 × 100 Mbps RJ-45 connector/24 × 100 Mbps RJ-45 connector
Cable type Standard (straight-through) Ethernet cable/crossover Ethernet cable
Operation mode Auto-sensing 10M/100 Mbps, full duplex/half duplex
Ethernet interfaces on network adapters are usually medium dependent interfaces (MDIs). Cross
medium dependent interfaces (MDIXs) are another type of Ethernet interfaces, which are usually used
on hubs and LAN Switches.
Interface LEDs
Figure 3-3 shows the XMIM-16FSW panel.
Figure 3-3 XMIM-16FSW panel
Figure 3-4 shows the XMIM-24FSW panel.
Figure 3-4 XMIM-24FSW panel
Each 10/100 Mbps Ethernet interface on the panel has two corresponding LEDs. One is yellow and the
other is green.
Table 3-5 describes these LEDs.