H3C Technologies H3C MSR 50 - Manual (Page 244)

4-49
Attribute Description
Interface rate 44.736 Mbps
Cable T3 cable (75-ohm coaxial cable)
Operating mode
T3
CT3
Supported service T3 leased line
Interface LEDs
The following figure illustrates an FIC-1CT3 panel.
Figure 4-60 FIC-1CT3 panel
The following table describes the LEDs on the module panel.
Table 4-40 LEDs on the FIC-1CT3 panel
LED Description
LINK/ACT
z
ON means the carrier signal has been received.
z
OFF means no carrier signal has been received.
z
Blinking means data is being transmitted or/and received.
LP/AL
z ON means the interface is in a loopback.
z
Blinking means an AIS, LFA, or RAI alarm signal is present.
z
OFF means no loopback or alarm is present.
Note:
AIS = Alarm indication signal; LFA = loss of frame alignment; RAI = Remote alarm indication
Interface cable
Refer to the FIC-1CE3.
The interface cable for the FIC-1CT3 is the same as that for the FIC-1CE3 and is connected in the
same way.
xDSL Interface Module
z
FIC-1SHL-4W
z
FIC-1G.SHDSL