H3C Technologies H3C MSR 50 - Manual (Page 197)

4-2
z
Full duplex and half-duplex, with the former in common use
Interface attributes
The interface attributes of the FIC-16FSW/DFIC-24FSW are given in the following table:
Table 4-1 Interface attributes of the FIC-16FSW/FIC-16FSW-PoE/DFIC-24FSW/DFIC-24FSW-PoE
Attribute
FIC-16FSW/FIC-16FSW-PoE
module
DFIC-24FSW/DFIC-24FSW-PoE module
Connector
RJ-45
SFP
Interface type MDI/MDIX
Number of connectors
16 × 100 Mbps RJ-45 connectors
one 1000 Mbps RJ-45 connectors
One SFP connector 24 × 100 Mbps RJ-45 connectors
Two 1000 Mbps RJ-45 connectors
Two SFP connectors
Cable type
Standard (straight-through) Ethernet cable
Crossover Ethernet cable
Operating mode
10/100 Mbps autosensing
Full/half duplex
MDI stands for Media Dependent Interface of the Ethernet. Normally, the interfaces on the network
cards belong to this type. Cross Media Dependent Interface (MDIX) is usually adopted on HUBs or LAN
switches.
Interface LEDs
FIC-16FSW/FIC-16FSW-PoE panel is shown in the following figure:
Figure 4-1 FIC-16FSW/FIC-16FSW-PoE panel
DFIC-24FSW/DFIC-24FSW-PoE panel is shown in the following figure:
Figure 4-2 DFIC-24FSW/DFIC-24FSW-PoE panel