H3C Technologies H3C MSR 50 - Manual (Page 17)

1-8
Step1 Place the rear panel of the Router towards you;
Step2 Turn off the power switch of the Router and unplug the power cord;
Step3 Take out the SIC and align its remote edge with the edge of the slot on the Router’s rear panel;
Step4 Push the SIC into the Router until it closely mates with the rear panel of the Router;
Step5 Fasten the SIC into the Router with captive screws;
Step6 Power on the Router, and check the LEDs of the corresponding slot on the front panel: after the
initialization of the SIC, ON means that the SIC is operating normally and OFF means that its
Power-On Self-Test (POST) has failed. In the latter case, please contact your agent.
Figure 1-2 Installing SIC
Removing a SIC
Follow these steps to remove a SIC:
Step1 Place the rear panel of the Router towards you;
Step2 Turn off the power switch of the Router and unplug the power cord;
Step3 Unplug all the network interface cables connected to the rear panel of the Router;
Step4 Remove the captive screws on both sides of the SIC using the flat-blade screwdriver;
Step5 Pull the SIC outward until it is completely taken out of the Router chassis.
Installing/Removing a MIM
Tools required
z
Flat-blade screwdriver
z
ESD-preventive wrist strap and ESD-preventive glove
Installing a MIM
Follow these steps to install a MIM:
Step1 Place the rear panel of the Router towards you;
Step2 Turn off the power switch of the Router and unplug the power cord;
Step3 Select a slot and insert the MIM along the guides in the slot until it contacts the rear panel of the
Router;
Step4 Fix the MIM into the Router with captive screws;
Step5 Power on the Router, and check the LEDs of the corresponding slot on the front panel: ON means that
the MIM is operating normally and OFF means that the POST of the MIM has failed. In the latter case,
please contact your agent.