H3C Technologies H3C MSR 50 - Manual (Page 98)

2-78
z
HSDPA
Interface attributes
Table 2-65 Interface attributes of the SIC-3G-TD module
Attribute Description
Connector type
TNC: For connecting an antenna and accessing WLANs.
RJ-45: For connecting to a third-party WLAN debugging and testing software
such as CAIT of Qualcomm.
Number of connectors
1 TNC RF
1 RJ-45
Interface standard
TNC RF: Omni antenna, supporting GPRS/EDGE/TD-SCDMA//HSDPA
RJ-45: RS-232
Cable type
TNC RF: None
RJ-45: AUX cable
Rates
z
HSDPA (downlink: 2.8 Mbps, uplink: 384 Kbps)
z
TD-SCDMA (downlink: 384 Mbps, uplink: 384 Kbps)
z EDGE (downlink: 236.8 Kbps, uplink: 236.8 Kbps)
z GPRS (downlink: 85.6 Kbps, uplink: 85.6 Kbps)
Services GPRS/EDGE/TD-SCDMA/HSDPA
Interface LEDs
SIC-3G-TD panel is shown in the following figure:
Figure 2-93 SIC-3G-TD panel
The following table describes the LEDs on the SIC-3G-TD panel:
Table 2-66 Description of the LEDs on the SIC-3G-TD panel
LED Description
WWAN
z
Steady green means that a link is present.
z
Blinking green means that data is being transmitted or received.
RSSI
z
Steady green means strong signal.
z
Blinking green means middle or low signal.
z OFF means weak signal or no signal.
TD
z
Steady yellow means the service is valid.
z
OFF means no service.
HSDPA
z
Steady yellow means the service is valid.
z
OFF means no service.
Interface cable
1) TNC antenna