H3C Technologies H3C MSR 50 - Manual (Page 159)

3-55
Figure 3-62 Jumper settings of the MIM-4BSE (example)
S1
S2 S3
S4 S5
S6 S8
S7
2 3 0 1
The following table describes how to set jumpers.
Table 3-49 Set the jumpers on the MIM-4BSE
Jumper settings & description Default
S2
z
To use a 100-ohm matched resistance for data transmission,
place the jumper over pins 1 and 2.
z To do otherwise, place the jumper over jump pins 2 and 3.
z
See Figure 3-62 .
Interface 0
S1
z
To use a 100-ohm matched resistance for data receiving, place
the jumper over jump pins 1 and 2.
z To do otherwise, place the jumper over jump pins 2 and 3.
z
See Figure 3-62 .
S4
z
To use a 100-ohm matched resistance for data transmission,
place the jumper over pins 1 and 2.
z To do otherwise, place the jumper over jump pins 2 and 3.
z See Figure 3-62 .
Interface 1
S3
z
To use a 100-ohm matched resistance for data receiving, place
the jumper over jump pins 1 and 2.
z To do otherwise, place the jumper over jump pins 2 and 3.
z
See Figure 3-62 .
S6
z
To use a 100-ohm matched resistance for data transmission,
place the jumper over pins 1 and 2.
z To do otherwise, place the jumper over jump pins 2 and 3.
z
See Figure 3-62 .
Interface 2
S5
z
To use a 100-ohm matched resistance for data receiving, place
the jumper over jump pins 1 and 2.
z To do otherwise, place the jumper over jump pins 2 and 3.
z See Figure 3-62 .
S8
z
To use a 100-ohm matched resistance for data transmission,
place the jumper over pins 1 and 2.
z To do otherwise, place the jumper over jump pins 2 and 3.
z
See Figure 3-62 .
Interface 3
S7
z
To use a 100-ohm matched resistance for data receiving, place
the jumper over jump pins 1 and 2.
z To do otherwise, place the jumper over jump pins 2 and 3.
z See Figure 3-62 .
The jumpers are
placed over
jump pins 2 and
3, meaning
100-ohm
matched
resistances are
not used.
Interface LEDs
The following figure illustrates the MIM-4BSE panel.