Yokogawa Touch Screen GP20 - Manual (Page 183)

1-169
IM 04L51B01-01EN
Configuring the GX/GP
1
2
3
4
5
App
Note
• Before initializing, back up necessary setup parameters and other data.
Refer to page 1-162 in section 1.21.1, “Saving the Setting Parameters”
• Initialization does not initialize the A/D calibration password.
If you forget the password, you will not be able to perform A/D calibration. Make sure you do not
forget the password.
• When execute initialization, the message “Restart is required to reflect this changes. Continue?”
may appear. Tap OK, and the GX/GP will automatically restart with the specified language.
Initializing a Specific Item
1
Press MENU.
The menu screen appears.
2
Tap the Browse tab and then Initialize Calibration.
The menu screen appears.
3
Tap Initialize all under Initialize and then Off.
4
To initialize the security settings, tap Security settings and then On. Otherwise, tap
Off.
5
To initialize the settings other than the security settings, tap Other than Security
settings and then On. Otherwise, tap Off.
6
To initialize the data in the internal memory, tap Internal data and then On. Otherwise,
tap Off.
7
Tap Execute.
A confirmation screen is displayed.
8
Tap OK.
The settings are initialized. The message “Execution is complete.” will appear.
Operation complete
Note
• Before initializing, back up necessary setup parameters and other data.
Refer to page 1-162 in section 1.21.1, “Saving the Setting Parameters”
Explanation
Channel Assignment in Group Settings through Initialization
If you initialize, channels will be automatically assigned on the basis of the installed
modules. If necessary, change the channel assignments for your purpose.
1.24 Initializing and Calibrating the System (Initialization, reconfiguration, touch screen calibration)