Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 180)

158 Fabric OS Message Reference
53-1003140-01
AUTH-1011
5
AUTH-1011
Message
Failed to register for failover operation: switch <switch number> error <error
code>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1012
Message
Authentication <code> is rejected: port <port number> explain <explain code>
reason <reason code>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the specified authentication is rejected because the remote entity does not support
authentication.
Recommended
Action
Verify the hash type, protocol, group, and authentication policy using the authutil --show command.
AUTH-1013
Message
Cannot perform authentication request message: port <port number>, message code
<message code>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the system is running low on resources when receiving an authentication request. Usually
this problem is transient. The authentication may fail.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.