Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 446)

424 Fabric OS Message Reference
53-1003140-01
FICN-1042
5
FICN-1042
Message
HostTapeIng:FICON Cancel received Path=0x<VEPortNumber HostDomain HostPort
DeviceDomain><DevicePort LPAR CUADDR DeviceAddr> state=0x<the current emulation
state for this device>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates a job was canceled during a Tape Write Pipelining.
Recommended
Action
If this was an unexpected event (cancel is normally an operator event), contact your vendor's customer
support for assistance.
FICN-1043
Message
HostTapeIng::FICON Selective Reset:Path=0x<VEPortNumber HostDomain HostPort
DeviceDomain><DevicePort LPAR CUADDR DeviceAddr> state=0x<the current emulation
state for this device> LastCmds=0x<the last 4 commands received from the channel
for this device> LastStatus=0x<the last 4 status values presented to the channel
for this device>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that protocol errors in emulation in the Control Unit or network errors can cause a Selective
Reset.
Recommended
Action
If this was an unexpected event, contact your vendor's customer support for assistance.
FICN-1044
Message
HostTapeIng:FICON Selective Reset:Path=0x<VEPortNumber HostDomain HostPort
DeviceDomain><DevicePort LPAR CUADDR DeviceAddr> Elapsed Time=<the number of
seconds since the last IO started for this device>.<the number of milliseconds
since the last IO started for this device> seconds.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that protocol errors in emulation in the Control Unit or network errors can cause a Selective
Reset.
Recommended
Action
If this was an unexpected event, contact your vendor's customer support for assistance.