Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 415)

Fabric OS Message Reference 393
53-1003140-01
FCR-1048
5
Recommended
Action
No action is required.
FCR-1048
Message
On EX port (<port number>) setting port <credit type> credits failed.
Message Type
LOG | FFDC
Severity
ERROR
Probable Cause
Indicates that the indicated credit type was not set. Setting port credits failed.
Recommended
Action
Send the First Failure Data Capture (FFDC) log to the support.
FCR-1049
Message
EX_Port (<port number>) received an ELP command that is not supported.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates an incoming exchange link parameter (ELP) command that is not supported.
Recommended
Action
Use the portEnable and portDisable to enable or disable the port.
If the problem persists, contact your switch service provider.
FCR-1053
Message
Port <port number> was disabled, <disable reason>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the specified port was disabled because of a mismatched configuration parameter.
Recommended
Action
Use the specified disable reason to identify a possible configuration parameter mismatch between the
EX_Port and the switch at the other end of the link.