Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 235)

Fabric OS Message Reference 213
53-1003140-01
C3-1001
5
C3 Messages
C3-1001
Message
S<slot number>,P<port number>(Bp<blade port number>) user_idx:<User port index>
[PID 0x<24 bit FC address>] faulted due to SFP validation failure. Check if the
SFP is valid for the configuration.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a deteriorated small form-factor pluggable (SFP) transceiver, an incompatible SFP transceiver
pair, or a faulty cable between the peer ports.
Recommended
Action
Verify that compatible SFP transceivers are used on the peer ports, the SFP transceivers have not
deteriorated, and the Fibre Channel cable is not faulty. Replace the SFP transceivers or the cable if
necessary.
C3-1002
Message
Port <port number> chip failed due to an internal error.
Message Type
LOG | FFDC
Severity
ERROR
Probable Cause
Indicates an internal error. All the ports on the blade or switch will be disrupted.
Recommended
Action
To recover a bladed system, execute the slotPowerOff and slotPowerOn commands on the blade. To
recover a non-bladed system, execute the fastBoot command on the switch.
C3-1004
Message
S<slot number>,C<chip index>: Invalid DMA ch pointer, chan:<Channel number>,
good_addr:0x<Good address> bad_addr:0x<Bad address>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates an internal error in the application-specific integrated circuit (ASIC) hardware that may degrade
the data traffic.
Recommended
Action
Reboot the system at the next maintenance window. If the problem persists, replace the blade.