Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 970)

948 Fabric OS Message Reference
53-1003140-01
XTUN-1006
5
XTUN-1006
Message
FCIP FC frame drop due to transmit timeout on slot=<FX8-24 Slot Number (0 for 7800
and 7840)> DP=<FX8-24/7840 DP Number (or 0 if 7800)> BLS=<Blaster Image Number (0
or 1)> DR=<FC Descriptor Ring Number> Frames Dropped=<Number of FC frames that
were dropped>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that a Fibre Channel (FC) Send frame timeout occurred and the frames were dropped from the
SW queue.
Recommended
Action
This error indicates that there is a slow draining device or a hung Blaster TX Descriptor Ring.
XTUN-1007
Message
FCIP FC frame drop due to truncated receive on slot=<FX8-24 Slot Number (0 for
7800 and 7840)> DP=<FX8-24/7840 DP Number (or 0 if 7800)> BLS=<Blaster Image
Number (0 or 1)> DR=<FC Descriptor Ring Number> Frames Dropped=<Number of FC
frames that were dropped>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that a Fibre Channel (FC) Received frame event was posted, but the frame was dropped due to
an invalid receive length. This error occurs only on faulty hardware.
Recommended
Action
Contact your vendor's customer support for assistance.
XTUN-1008
Message
FCIP Control block memory usage slot=<FX8-24 Slot number (0 for 7800 or 7840)>
DP=<FX8-24/7840 DP number (or 0 if 7800)> Allocated=<The total allocated bytes
from the pool> Free=<The total free bytes remaining in the pool> Total=<The total
size of the pool>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the control block memory pool has crossed the usage threshold. This message is
generated when a significant amount of control block memory has been allocated from the free pool. This
memory is limited and you should monitor for events that indicate that greater than 80 percent of the pool
has been allocated.
Recommended
Action
Contact your vendor's customer support for assistance.