Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 434)

412 Fabric OS Message Reference
53-1003140-01
FICN-1006
5
FICN-1006
Message
FICON GEPort <GE port number> TID <Tunnel number> Feature Change failed Xrc <1 or
0 - XRC Emulation Enabled or Disabled> TapeWrt <1 or 0 - Tape Write Emulation
Enabled or Disabled> TapeRd <1 or 0 - FICON Tape Read Emulation Enabled or
Disabled> TinTir <1 or 0 - FICON TIN/TIR Emulation Enabled or Disabled> DvcAck <1
or 0 - FICON Device Level Ack Emulation Enabled or Disabled> RdBlkId <1 or 0 -
FICON Write Emulation Read Block ID Emulation Enabled or Disabled>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the feature change has failed because the FCIP tunnel ID associated with the FICON
tunnel is still active.
Recommended
Action
Disable the applicable FCIP tunnel to make the feature change effective.
FICN-1007
Message
DevDiskEgr:FICON Selective Reset:Path=0x<VEPortNumber HostDomain HostPort
DeviceDomain><DevicePort LPAR CUADDR DeviceAddr> State=0x<Current Emulation
State> stat_array=0x<the Last 4 Status values that were received from the device>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a Selective Reset from the channel was received as either a normal part of path recovery or the
starting sequence in an error case.
Recommended
Action
If there was a job failure associated with this event, contact your vendor's customer support.
FICN-1008
Message
DevDiskEgr:FICON Purge Path received Path=0x<VEPortNumber HostDomain HostPort
DeviceDomcontactain><DevicePort LPAR CUADDR DeviceAddr>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a FICON Purge Path was received from the channel as a part of path recovery.
Recommended
Action
If there was a job failure associated with this event, contact your vendor's customer support for
assistance.