Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 511)

Fabric OS Message Reference 489
53-1003140-01
FW-1045
5
FW-1045
Message
<Label>, value has changed(High=<High value>, Low=<Low value>). Current value is
<Value> <Unit>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) voltage has changed. If the supplied
voltage of the SFP transceiver is outside of the normal range, this may indicate a hardware failure.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation. If the message persists, replace the SFP.
FW-1046
Message
<Label>, is below low boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) voltage has fallen below the low
boundary.
Recommended
Action
Verify that your optical components are clean and function properly. Replace deteriorating cables or
SFPs. Check for damage from heat or age.
FW-1047
Message
<Label>, is above high boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) voltage has risen above the high
boundary.
Recommended
Action
The supplied current of the SFP transceiver is outside of the normal range, indicating possible hardware
failure. If the current rises above the high boundary, you must replace the SFP.