Lenze E94AYAE SM301 - Manual (Page 117)

Safety engineering
Appendix
Module internal codes
1
l
117 EDS94AYAE EN 7.0
Index: Data type: Name: Parameter:
C15035 CAS: Cascading UNSIGNED_8 9540 d = 2544 h
Safe cascading
Selection list (Lenze setting bold) Information
0 No cascading (As of SM301 V1.1)
4 Cascading with SD−In4
þ Read access } Write access o CINH o PLC-STOP o No transfer
C15036 CAS: Stop delay UNSIGNED_16 9539 d = 2543 h
Circulation time of safe cascading
Display area (min. value | unit | max. value) Information
0 MS 65535 (As of SM301 V1.1)
l Display of the time that passes from switching the
SD−Out1 output to OFF state to the detection of the
OFF state at the SD−In4 input. This information may
be helpful for system commissioning/maintenance.
l If "0 ms" is displayed after a stop, another safety
module has activated the stop via the cascade.
l The time is displayed until the next system
acknowledgement.
þ Read access o Write access o CINH o PLC-STOP o No transfer
C15040 Input image BITFIELD_32 9535 d = 253F h
Input image of the external module inputs of the safety module, shown in channels.
Value is bit coded: Information
Bit 0 SD-In1 channel A
Safe input 1
Bit 1 SD-In1 channel B
Bit 2 SD-In2 channel A
Safe input 2
Bit 3 SD-In2 channel B
Bit 4 SD-In3 channel A
Safe input 3
Bit 5 SD-In3 channel B
Bit 6 SD-In4 channel A
Safe input 4
Bit 7 SD-In4 channel B
Bit 8 reserved
...
Bit 15 reserved
Bit 16 AIE AIE input (fault acknowledgement)
Bit 17 AIS AIS input (restart acknowledgement)
Bit 18 Module switch
Bit 19 reserved
...
Bit 31 reserved
þ Read access o Write access o Controller inhibit o PLC-STOP o No transfer