Lenze E94AYAE SM301 - Manual (Page 26)

Safety engineering
Device modules
SM301 safety module
1
l
26 EDS94AYAE EN 7.0
1.2.3.6 Commissioning
ƒ For commissioning and safe parameter setting, the Lenze »Engineer« PC
software from version 1.4 must be used.
If you select the safety module in the Project view, various tabs are available in the
Operating range via which the safety module can be parameterised. In all other
program parts the parameters of the safety module can only be read. Thus, the write
access of these parameters (codes) is marked with
}.
ƒ Settings in or at the module:
– Safety address
– Safe parameter setting of the functions to be used
ƒ Required settings in the standard device:
– C00214, type of safety module
– Implementation of the SM301 into the drive application by evaluating the control
information and status information.
ƒ During commissioning and after the replacement of a module it is vital to check the
safety function. Additional information contains the "Acceptance" chapter. (
¶ 110).