MTS Model FlexTest SE - Manual (Page 81)

Models FlexTest® IIm/GT/SE Controller Hardware FlexTest GT Controller Connections 81
Chapter 3
FlexTest GT Controller Connections
This section describes the cable connections to the Model 493.10 Chassis.
Note For information on connecting power cables, see “Connecting Electrical
Power” on page 38.
Contents CE EMC Compliant Cabling 83
Typical Cabling 84
Cable Part Numbers 85
Model 493.40 I/O Carrier Connections 87
Sensor Connections 88
Sensor Cables 100
Shunt Calibration/Bridge Completion Resistor Installation 103
Transducer Identification Modules 106
Valve Connections 108
Multiple Universal Driver Connections 112
Analog I/O Connections 114
Accelerometer Connections 119
Encoder Connections 121
Remote Setpoint Adjust Connections 123
ADDA II Connections 124
Emergency Stop Connections 129
J25 Hydraulic Power Unit Connection 131
Station Connections 134
J28 Hydraulic Service Manifold Connector 134
J29 Load Unit 136
J43 Interlock 137
J44 Run/Stop 138
J49 Auxiliary Power 140