Add signals to waveform viewer dialog, 17 add signals to waveform viewer dialog – Achronix ACE Version 5.0 User Manual

Page 208

Advertising
background image

Dialogs

Chapter 3. Concepts

Add Signals to Waveform Viewer Dialog

This dialog allows the user to add signals to the table and waveform area of the

VCD Waveform Editor

. The

dialog allows the user to either unhide signals which were previously hidden via the Remove button in the
VCD Waveform editor, or add duplicates of already-shown signals to the table and waveform. The selected
signals may added at either the top or bottom of the table/waveform via the dialog. If the user wishes to
move the signals to a location other than the top or bottom, this must be done via the Move Up and Move
Down

buttons on the VCD Waveform editor.

Figure 3.108: Add Signals to Waveform Viewer Dialog

The majority of the dialog is taken up by an area listing the signals. The signals listed will vary depending
upon the radio-button currently selected in the dialog.

Add Signals to Waveform Viewer Dialog Actions

Action

Description

Select from All
Signals

When selected, this radio button will cause the list to be populated with all the
signals contained in the current VCD file.

Select from
Hidden Signals

When selected, this radio button will cause the list to be populated with all the
signals found in the VCD file which are currently hidden. (Signals ’removed’ from
the VCD Waveform editor’s signal table are considered hidden.) If no signals are
currently hidden, the list of hidden signals will be empty.

Append

This button appends the currently-selected signal to the bottom of the VCD
Waveform Editor’s signal table.

1)

Insert

This button inserts the signal currently selected in the dialog’s list below the signal
currently selected in the VCD Waveform Editor’s signal table. If no signal was
selected in the VCD Waveform Editor’s signal table when the Add. . . button was
pressed to bring up this dialog, the signal selected in the dialog is inserted at the top
of the VCD Waveform Editor’s signal table.

1)

Close

This button closes the dialog.

Note:

UG001 Rev. 5.0 - 5th December 2012

http://www.achronix.com

196

Advertising