Achronix ACE Version 5.0 - Manual (Page 362)

run generate bitstream Chapter 5. Tcl Command Reference
run generate bitstream
run generate bitstream [-outputdir < arg > ] [-reportsdir < arg > ] [-debugdir
< arg > ] [-chainfile < arg > ] [-aeskey < arg > ] [-monitor delay count < arg > ]
[-flash] [-flash4x] [-hex] [-cpu] [-compress] [-nocompress]
This command generates a bitstream file for programming the target device.
Argument Required/Optional Description
[-outputdir < arg > ] Optional Output directory name
[-reportsdir < arg > ] Optional The optional -reportsdir <dir>
option is used to override the
default location for report files
during this step.
[-debugdir < arg > ] Optional The optional -debugdir <dir>
option is used to override the
default location for debug files
during this step.
[-chainfile < arg > ] Optional The optional -chainfile <file>
may be used to override the
chainfile set in the active Impl
[-aeskey < arg > ] Optional Key used for encryption. If not
given, key is taken from impl. If
not active in impl, the bitstream
is not encrypted.
[-monitor delay count
< arg > ]
Optional CRAM monitor delay count for
RadRunner. If not given, count
is taken from impl. If not active
in impl, the default value is
assumed.
[-flash] Optional The optional -flash option may
be used to output a serial flash
binary file format instead of the
default STAPL format
[-flash4x] Optional The optional -flash4x option
may be used to output 4
additional 4x serial flash binary
file format outputs
[-hex] Optional The optional -hex option may be
used to output an additional
raw hex file format output
[-cpu] Optional The optional -cpu option may be
used to output an additional
CPU Mode file format output
[-compress] Optional Compress the output file
[-nocompress] Optional Write output as plain-text file
(default)
UG001 Rev. 5.0 - 5th December 2012 http://www.achronix.com 350