Achronix ACE Version 5.0 - Manual (Page 388)

Chapter 6. Revision History
* now obsolete/deprecated:
ideal reset, initialize flow, load flowscripts,
run auto cst
• Updated to match ACE 4.1 functionality additions and changes:
– Added new IP Configuration Editor support for the 22i parts
* Added
22i Advanced PLL IP Configuration Editor
* Added
22i DDR3 Configuration Editor
* Added
22i SerDes Configuration Editor
– Added the new Clock Regions View
– Added the new Netlist Browser View
– Updated Floorplanner view to reflect new Clock Nets functionality
* new ’Clock Nets’ layer
* related Selection/Deselection behavior
* related Instance Flylines behavior
* related Tooltips behavior
• Updated to match ACE 4.0 functionality additions and changes:
– IP Configuration Perspective:
* Removed all (now-obsolete) Speedster (SPD60) IP Configuration Editors
* Added
22i FIFO Configuration Editor
* The
Tcl Console View is now displayed by default in the IP Perspective
– Updated the Multiprocess View to reflect the name change of the third-party tool ”Sun Grid
Engine” to ”Oracle Grid Engine”.
– Updated Critical Path Diagram View and Critical Paths View to support new critical path types
”Setup Check Met” and ”Setup Check Violated”
– Updates to Floorplanner View :
* Updated the ”Route Drawing Mode”s, removing 3-corner mode and renaming Flyline
drawing mode to Actual Route
* Tooltip choices in the
Package View and Floorplanner View are now cumulative, instead of a
single choice
* Tooltip choices and Label choices are now identical lists in the same order for the
Floorplanner View and Package View.
* The button formerly named ”Save Placement” is now named ”Save Pre-Placement
Constraints”
– The chosen target device name for the active implementation is now displayed in the ACE
window’s titlebar
– Updated TclConsole Command Auto-Completion now that the console beeps if auto-completion
fails.
Version 3.2.0:
• Updated to match ACE 3.2 functionality additions and changes:
– Updated the Panning page to mention the new ”Ctrl-arrow” scroll support in the Floorplanner
View
– Updated the Floorplanner View Preference Page and the Panning page explaining the new ”draw
Background-only” panning mode in the Floorplanner View .
* (This is an optimization intended for workstations with slow drawing/scrolling/panning
performance.)
UG001 Rev. 5.0 - 5th December 2012 http://www.achronix.com 376