Achronix ACE Version 5.0 - Manual (Page 364)

run prepare Chapter 5. Tcl Command Reference
[-structural clustering
< arg > ]
Optional Turn on structural clustering
during placement (1,0)
[-verbose < arg > ] Optional Produce extra reports and
intermediate results (1,0)
[-incremental] Optional Run placement in incremental
mode
run post process
run post process [-reportsdir < arg > ] [-debugdir < arg > ]
This command post-processes the routed design to insert reset and other Achronix-specific technologies.
Argument Required/Optional Description
[-reportsdir < arg > ] Optional The optional -reportsdir <dir>
option is used to override the
default location for report files
during this step.
[-debugdir < arg > ] Optional The optional -debugdir <dir>
option is used to override the
default location for debug files
during this step.
run prepare
run prepare [-outputdir < arg > ] [-reportsdir < arg > ] [-debugdir
< arg > ] [-partname < arg > ] [-constraints < arg > ] [-netlists < arg > ]
[-autoselect top module < arg > ] [-top module < arg > ]
This command clears the current netlist and constraints data, then loads all the design files for the active
implementation, runs design checks, and compiles the design into an Achronix design.
Argument Required/Optional Description
[-outputdir < arg > ] Optional The optional -outputdir <dir>
option is used to override the
default location for output files
during this step.
[-reportsdir < arg > ] Optional The optional -reportsdir <dir>
option is used to override the
default location for report files
during this step.
[-debugdir < arg > ] Optional The optional -debugdir <dir>
option is used to override the
default location for debug files
during this step.
[-partname < arg > ] Optional The optional -partname
<
partName> option is used to
override the name of the FPGA
part to use during this step.
UG001 Rev. 5.0 - 5th December 2012 http://www.achronix.com 352