Achronix ACE Version 5.0 - Manual (Page 365)

run remove reset Chapter 5. Tcl Command Reference
[-constraints < arg > ] Optional The optional -constraints <file1
file2 . . . > option overrides the
list of SDC constraint files to use
during this step.
[-netlists < arg > ] Optional The optional -netlists <file1 file2
. . . > option overrides the list of
verilog netlist files to use during
this step.
[-autoselect top module
< arg > ]
Optional The optional
-autoselect top module
<
value> option overrides
whether or not the top module
name for this step should be
automatically selected. A value
of 1 will cause the name to be
automatically selected. A value
of 0 will cause the -top module
option value to be used.
[-top module < arg > ] Optional The optional -top module
<
moduleName> option
overrides the top module name
for this step when the
-autoselect top module option is
set to 0.
run remove reset
run remove reset
Remove reset logic from routed design
run route
run route [-outputdir < arg > ] [-reportsdir < arg > ] [-debugdir < arg > ]
[-noreport] [-nocore] [-timing < arg > ]
This command routes the design.
Argument Required/Optional Description
[-outputdir < arg > ] Optional The optional -outputdir <dir>
option is used to override the
default location for output files
during this step.
[-reportsdir < arg > ] Optional The optional -reportsdir <dir>
option is used to override the
default location for report files
during this step.
[-debugdir < arg > ] Optional The optional -debugdir <dir>
option is used to override the
default location for debug files
during this step.
[-noreport] Optional Do not write the routing report
353 http://www.achronix.com UG001 Rev. 5.0 - 5th December 2012