BUCHI NIRWare - Manual (Page 170)

164

NIRWare Suite NIRWare 1.5 Software Manual
5. Fiber Optic Liquids 8 scans (Qualitative)
16 scans (Quantitative)
6. Fiber Optic Solids 8 scans (Qualitative)
32 scans (Quantitative)
7. Liquids 8 scans (Qualitative)
16 scans (Quantitative)
8. Solids with Vial Add-On 8 scans (Qualitative)
32 scans (Quantitative)
8. Solids with XL Add-On 8 scans (Qualitative)
32 scans (Quantitative)
8. Solids with Petri Add-On 8 scans (Qualitative)
32 scans (Quantitative)
8. Solids with Tablet Add-On 8 scans (Qualitative)
32 scans (Quantitative)
It is possible to enter a different number of scans optimized to the task.
To set back the default value for the instrument configuration, click on this
button .
Resolution Select check box:

Checked = full instrument resolution 8cm
-1
with Boxcar (default)

Unchecked = half resolution (16cm
-1
) with Boxcar (default for Solids
Transmittance)
The default resolution is recommended.
Apodisation 1 for
Phase Correction
(Don't change!) This parameter is for information only and shows the apodisation function
1 used for phase correction.
A different Apodisation function may be available in the future (Default
function = Blackman)
Apodisation 2 for
Phase Correction
(Don't change!) This parameter is for information only and shows the apodisation function
2 used for phase correction.
A different Apodisation function may be available in the future (Default
function = Blackman)
Apodisation for
Interferogram (Don't
change!) This parameter is for information only and shows the apodisation function
used for interferogram treatment.
A different Apodisation function may be available in the future (Default
function = Blackman)
Transfilter Don't change!
This function is only used during the phase correction.

Checked = Transfilter activated

Unchecked = Transfilter deactivated (default)
Datapoints Use with care.
Recommendations for lower wavenumber limit 4000cm
-1
and Datapoint
interval 4: