BUCHI NIRWare - Manual (Page 98)

92

Tutorial NIRWare 1.5 Software Manual
The parameters L1, L2 and T are given by the respective Pharmacopeia.
Choosing "Individual Monograph", the values for L1, L2 and T can be edited.

It is recommended to use the Autoname function of the Operator Configuration to create
sample names automatically from basic entries as shown in the below example (autoname
part 1 = Batch information; autoname part 2 = none; autoname part 3 = Counter).
If CUT is activated in the application, the settings for "Number of repetition of measurements in case of an
Out Of Specification" case will be always 0 and "Number of measurement sequences" will be always 1
(even if specified otherwise in the application).

After all changes on settings are made, set the application in the approved state.

Start the operator and select the developed application for CUT.