BUCHI NIRWare - Manual (Page 213)

NIRWare 1.5 Software Manual NIRWare Suite

207
Select one or more measurement sequences and click on in the menu bar.
In case some report entries are listed in the file tree on the left, the following message appears:
Close all entries in the file tree list before continue deleting measurement sequences without prediction
results by selecting each entry individually an click on the red cross button.
Delete and disable Measurement sequences with prediction results
Measurement sequences with prediction results (sequence type filter setting 1 in selection table) can be
deleted as long as they are in the life cycle state created or checked. Only measurement sequences
which are put in the life cycle state approved can not be deleted.
Once a measurement sequence is in the life cycle state 'Approved', it will be possible to hide the
measurement sequences by putting them in the Life Cycle state "Disabled". The results remain in the
database but samples and measurement sequences will not be visible in the tables any more.
In case samples of a particular measurement sequence are used in a calibration, the sequence can not
be deleted or disabled.
Information about this can be found by selecting a single or group of measurement sequences in the
bottom window:
Select one or more measurement sequences and click on the red cross button in the menu bar.
In case some report entries are listed in the file tree on the left, the following message appears: