BUCHI NIRWare - Manual (Page 228)

222

NIRWare Suite NIRWare 1.5 Software Manual
For further information on the lifecycle philosophy and templates, see Templates .
6.4.4. NIRWare Configuration
The NIRWare Configuration dialog serves to set certain instrument parameters. To open it, in the file tree
on the left side of the NIRWare Management Console select Administrative Tools - NIRWare Config.
The following dialog opens:
The dialog consists of five areas:
Spectrometer Connection
The IP address on which the software should search for the NIRFlex N-500 instrument to establish the
communication can be selected from the drop-down list. Alternatively, you can click the Browse button to
create a selection list of all available NIRFlex N-500 spectrometers that are accessible on the network.
IMPORTANT NOTE
The browsing function can only find spectrometers if
- the spectrometer is switched on and connected to the network
- the spectrometer’s IP-address is within the same subnet as the PC that tries to connect
- no firewall interferes with the communication
When all this prerequisites are fulfilled, click Browse. After the searching procedure is finished, you can
select the IP Address of a spectrometer from the corresponding drop-down list.