Activating the primary lamp after lamp change, Reset instruments tcp/ip address to its default – BUCHI NIRWare User Manual
Page 330
324
NIRWare Operator
NIRWare 1.5 Software Manual
Reconnect the control system afterwards in order to establish the connection.
NOTE
The configuration of the instrument IP and the connection information in the database have to match.
To connect to a different instrument, it will be necessary to edit the connection information in the database
under Administrative Tools (NIRWare Management Console),
System service connects to the new address.
Reset instruments TCP/IP address to its default
To reset the TCP/IP address of the NIRFlex N-500 to its default address (192.168.1.1) push both buttons
START and STOP on the measurement cell continuously during power on for approximately 1 minute.
7.8.3. Activating the primary lamp after lamp change
When the system currently runs with the secondary lamp the following message will appear at the
opening of the NIRWare Operator: