BUCHI NIRWare - Manual (Page 183)

NIRWare 1.5 Software Manual NIRWare Suite

177
Start @ digit 10, read 6 digits -- > “222222” will go into “Batch” field;
Start @ digit 16, read 7 digits -- > “3333333” will go into “Analysis ID” field;
The leading four zeroes (“0000”) are used nowhere, and thus be discarded.
NOTE
The bar code must contain information about both, the Batch as well as the Expected Substance. These
two fields depend on each other.
Comment Field:
If activated, you can enter information in the Operator to describe the samples. The Comment Field with
its information will be displayed in the Sample Manager under 'Samples' and 'Measurements' at
corresponding entries.
In the NIRCal spectra selection filter the Comment Field will be shown for selection and the information is
displayed in the comment field of every spectrum related to these measurements.
6.2.14. Settings for LIMS
The use of LIMS Import or Export can be configured application-wise. For this purpose select Application
Designer - <YourApplication> - Operator Configuration - LIMS Configuration.
Per default the use of the LIMS export is deactivated. Only if this option is activated, AND the general
LIMS-settings are activated, the LIMS-interface will be used.
To ensure a proper functionality of applications with the NIRWare LIMS Interface, the following settings
are recommended:

The applications used with LIMS should be in the "approved" lifecycle state to prevent
changes on application parameters that are incompatible with the LIMS Import/Export
functions.

If LIMS Import is in use, all visible fields should be set to "read only" and "field reset" under
"Operator Configuration - Sample Description Fields".