BUCHI NIRWare - Manual (Page 173)

NIRWare 1.5 Software Manual NIRWare Suite

167
8. Solids with XL Add-On Interval (20 min)
8. Solids with Petri Add-On Interval (60 min)
8. Solids with Tablet Add-On Measure Sequence
External Reference
Interval Interval in minutes to measure the external reference, if the mode to
measure the
external reference was selected as “interval”.
Internal Reference
Mode Mode to measure the internal reference (not available for Solids
Transmittance). Choose from the following possibilities:

Disabled = No measurement for computing

Manual = Manual reference measurement

Measurement Sequence = at each start of a measurement sequence

Interval = regularly (see interval value below)

Temperature Drift = after a certain temperature drift of the
interferometer (see value below)

Batch = once after a new batch has been created
Default:
1. NIRMaster Interval (10 min)
2. Fiber Optic SMA (for
continuous measurement) Interval (10 min)
3. CheckMaster Transmittance n.a.
4. Solids Transmittance n.a.
5. Fiber Optic Liquids Interval (10 min)
6. Fiber Optic Solids Interval (10 min)
7. Liquids Disabled
8. Solids with Vial Add-On Disabled
8. Solids with XL Add-On Disabled
8. Solids with Petri Add-On Interval (10 min)
8. Solids with Tablet Add-On Disabled
Internal Reference
Interval Interval in minutes to measure the internal reference, if the mode to
measure the internal reference was selected as “interval”.
Max. Drift for
Reference
Temperature Maximum allowed drift in °C inside the NIRFlex N-500. If this maximum drift
is exceeded, the software will ask to do an SST and to measure external
and internal reference.
Sample holder rotation
for Petri dish Special parameter for Measurement Cell “NIRMaster” and “Solids with Petri
add-on ” to turn on or off the rotation.

Checked = rotation of petri dish add-on is turned on

Unchecked = rotation of petri dish add-on is turned off
Heater Temperature
Nominal Special parameter for Measurement Cell Liquids.
Set temperature in [°C] in cuvette holder for liquid measurements.
Default: 35°C
Range: ambient temperature (+10°C) to 65°C
Sample Gain Setting for NIRFlex Solids Transmittance.