68 poe mode – Interlogix NS3702-24P-4S Command Line Guide User Manual
Page 107
-107-
ping
The ping command allows you to test connectivity to a network host from the appliance
ip
ip
<ipv4_addr>
IP address
size
size
<size: 2-1452>
Default is 56 (excluding MAC, IP and ICMP headers)
Default:
N/A
Usage Guide:
To run Ping function for specific interface
Example:
To run Ping function (IP address: 10.10.10.10 with size 88 bytes) for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # ping ip 10.10.10.10 size 88
4.2.48.68 poe mode
Command:
poe mode { standard | plus }
poe
Power Over Ethernet.
mode
PoE mode.
plus
Set mode to PoE+ (Maximum power 30.0 W)
standard
Set mode to PoE (Maximum power 15.4 W)
Default:
N/A
Usage Guide:
To configure 802.3at/af mode for specific interface
Example:
To configure 802.3at mode for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe mode plus