Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 94)

-94-
To configure LACP port-priority (555) for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lacp port-priority 555
4.2.48.43 lacp role
Command:
lacp role active | passive
lacp
Enable LACP on this interface
role
Active / Passive (speak if spoken to) role
active
Transmit LACP BPDUs continously
passive
Wait for neighbour LACP BPDUs before transmitting
Default:
Active
Usage Guide:
To configure LACP role for specific interface
Example:
To configure LACP role (passive) for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lacp role passive
4.2.48.44 lacp timeout
Command:
lacp timeout fast | slow
lacp
Enable LACP on this interface
timeout
The period between BPDU transmissions
fast
T ransmit BPDU each second (fast timeout)
slow
Transmit BPDU each 30th second (slow timeout)
Default: