Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 166)

-166-
ip Internet Protocol
arp
Address Resolution Protocol
inspection
ARP inspection
translate
arp inspection translate all entries
interface
arp inspection entry interface config
GigabitEthernet 1 Gigabit Ethernet Port
10GigabitEthernet 10 Gigabit Ethernet Port
<vlan_id>
Select a VLAN id to configure
<mac_ucast>
Select a MAC address to configure
<ipv4_ucast>
Select an IP Address to configure
Default:
N/A
Usage Guide:
To translate dynamic entries into static ARP inspection table for specific interface.
Example:
To translate below dynamic entries into static ARP inspection table for GigabitEthernet 1/1.
Switch# configure terminal
Switch (config )# ip arp inspection translate interface GigabitEthernet 1/1 1
00:11:22:33:44:55 192.168.0.18
4.2.54 ip arp inspection vlan
Command:
ip arp inspection vlan <vlan_list> logging all | deny | permit
ip Internet Protocol
arp
Address Resolution Protocol
inspection
ARP inspection
vlan
arp inspection vlan setting
<vlan_list>
arp inspection vlan list
logging
ARP inspection vlan logging mode config
all
log all entries
deny
l og denied entries
permit
lo g permitted entries