Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 21)

-21-
Chapter 2 CONSOLE CLI MANAGEMENT
2.1 Terminal Setup
To configure th e system, connect a ser ial cable to a COM port on a PC or note book computer and to RJ-45 t ype of serial
(console) port of the Managed Switch.
Figure 2-1
Managed Switch Console Connectivity
A terminal pr ogram is re quired to make the software connection to th e Managed Switch. Windows' Hyper Terminal program
may be a good choice. The Hyper Terminal can be accessed from the Start menu.
1. Click
START
, then Programs, Accessories and then Hyper Terminal.
2. When the following screen appears, make sure that the COM port should be configured as:
 Baud
: 115200
 Data bits
: 8
 Parity
: None
 Stop bits
: 1
 Flow control
: None