3 requirements, User mode, Privileged mode – Interlogix NS3702-24P-4S Command Line Guide User Manual

Page 20: Global config mode, Interface config mode

Advertising
background image

-20-

The CLI provides the following modes:

User Mode

When the operator logs into the CLI, the User Mode is the initial mode. The User Mode contains a limited set of commands. The

command prompt shown at this level is:

Command Prompt: switch>

Privileged Mode

To have access to the full suite of comm ands, the operator must enter the Privileged Mode. T he Privileged Mod e requ ires

password authentication. From Privileged Mode, the operator can issue a ny Exec command to enter th e Global Configuration

mode. The command prompt shown at this level is:

Command Prompt: switch#

Global Config Mode

This mode permits the operat or to make modificati ons to the running configuration. General setup commands are gr ouped in

this mod e. F rom the Glob al Configuration mode, the op erator can enter the In terface Confi guration mode. T he c ommand

prompt at this level is:

Command Prompt: switch(Config)#

From the Global Config mode, the operator may enter the following configuration modes:

Interface Config Mode

Many features are enabled for a particular interface. The Interface commands enable or modify the operation of an interface. In

this mode, a physical port is set up for a specific logical connection operation. The command prompt at this level is:

Command Prompt: Switch(Interface <port#>)#

1.3 Requirements

Workstations

running Windows XP/Vista/7/8/, Windows 2003/2008, MAC OS X or l ater, Linux, UNIX, or oth er platforms

are compatible with TCP/IP protocols.

Workstations are installed with Ethernet NIC (Network Interface Card)

Serial Port

Connection (Terminal)

The above Workstations come with COM Port (DB9) or USB-to-RS-232 converter.

The above Workstations have been installed with terminal emulator, such as Hyper Terminal included in Windows

XP/2003.

Serial cable

-- one end is attached to the RS-232 serial port, while the other end to the console port of the Managed

Switch.

Ethernet Port

Connection

Network cables -- Use standard network (UTP) cables with RJ-45 connectors.

The above PC is installed with Web Browser and JAVA runtime environment plug-in.

Advertising