Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 164)

-164-
arp
Address Resolution Protocol
inspection
ARP inspection
Default:
N/A
Usage Guide:
To enable ARP inspection
Example:
To enable ARP inspection
Switch# configure terminal
Switch (config)# ip arp inspection
4.2.51 ip arp inspection entry interface
Command:
ip arp inspection entry interface [10GigabitEthernet | GigabitEthernet] <vlan_id>
<mac_ucast> <ipv4_ucast>
ip Internet Protocol
arp
Address Resolution Protocol
inspection
ARP inspection
entry
arp inspection entry
interface
arp inspection entry interface config
GigabitEthernet 1 Gigabit Ethernet Port
10GigabitEthernet 10 Gigabit Ethernet Port
<vlan_id>
Select a VLAN id to configure
<mac_ucast>
Select a MAC address to configure
<ipv4_ucast>
Select an IP Address to configure
Default:
N/A
Usage Guide:
To configure Static ARP Inspection Table.
Example:
To configure Static ARP Inspection Table as below table.