Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 271)

-271-
Example:
To configure the Access (below table) of SNMP
Switch# configure terminal
Switch (confi g)# snmp-server access default_rw_group model v2c level priv read
default_view write default_view
4.2.172 snmp-server community
Command:
snmp-server community { v2c <comm> [ ro | rw ] | v3 <v3_comm> [ <v_ipv4_addr>
<v_ipv4_netmask> ] }
snmp-server Set SNMP server's configurations
community
Set the SNMP community
v2c
SNMPv2c
<comm>
Community word
ro
Read only
rw
Read write
v3
SNMPv3
<V3Comm : word127>
Community word
<ipv4_addr>
IPv4 address
<ipv4_netmask>
IPv4 netmask
Default:
None
Usage Guide:
To configure the Read / Write / Source network Community of SNMP
Example:
To configure the Read / Write / Source network Community (below table) of SNMP
Switch# configure terminal