Toa N-8000 Series Ver.1.41 - Manual (Page 128)

3-32
Chapter 3: INSTALLATION & WIRING
7 mm*
* Approx. 5 mm for the N-8031MS
For cables, refer to p. 3-31 , Type of Cable.
Note
Do not solder plate on exposed inner cables when using a
stranded wire.
4.7. Connector Connection
4.7.1. Mini-clamp connector connection
Connect the mini-clamp connector supplied with the N-8000EX, the N-8010EX or the N-8000MI to a cable
using a commercially available tool (pliers).
Step 1. Cut off two-cable ends in equal length, and insert them
securely to a cover section (transparent side) of the
mini-clamp connector.
Note
Insert the cable without stripping the cable jacket.
For cables, refer to
p. 3-31 , Type of Cable.
Step 2. With a pair of pliers, lightly pinch the mini-clamp cover
and, after ensuring that the cable is securely inserted,
firmly squeeze on the cover.
Note
Squeeze on the mini-clamp cover until it is correctly
locked.
Step 3. Insert the wired connector (plug) into the exchange's connector (socket) until it locks into place.
Cover (transparent side)
Cable
Mini-clamp connector
(supplied with the
N-8000EX/8010EX/8000MI,
model 232D-02S1B-DA5
manufactured by DDK Ltd.)
Rear panel
4.7.2. Terminal plug connection
Step 1. Strip a cable jacket of approx. 7 mm (approx. 5 mm for the N-8031MS only) from the cable end.
Step 2. Loosen the terminal screws and insert the cables.
Note: This figure shows the N-8000EX.