Toa N-8000 Series Ver.1.41 - Manual (Page 58)

2-6
Chapter 2: FUNCTIONS AND OPERATION
2.2. Calling
2.2.1. Individual calls
• The desired party can be called by dialing its station number.
(The desired party can be called by dialing its station number without lifting the handset.)
• Conversation can begin when the called party responds and the call tone stops.
• A busy tone indicates that the called party is already engaged on another line.
Connection to the called party will occur as soon as the busy line is freed.
2.2.2. Master station calls
The pre-programmed master station can be called by pressing the door station's call button.
Note
Preprogram the master station to call to.
Programming can be performed by dialing operation of the multifunctional master station (refer to
p.7-7 ) or
using the supplied N-8000 Software program (refer to p.5-54, 5-59 ).
2.2.3. Redialing
Pressing the Redial key automatically redials the last dialed number.
Only the N-8000MS Multifunctional Master Station and the N-8500MS IP Multifunctional Master Station
permit selection from the most recent 10 numbers dialed.
Tip
Keys to be registered into the Redial key are the Dial keys (12 keys), the Paging key, and the Function key.
When using the N-8010MS/8011MS/8020MS/8031MS:
Press the Redial key to automatically redial the last dialed
number (individual call, paging, etc.)
Paging
[Example when dialing the paging last]
One-way conversation
One-way conversation
PTT
2.1.3. PTT conversation
This function makes announcements and
conversations possible to areas with a high
ambient noise level. Pressing the Push-to-talk
key during a conversation enables one-way
conversation from the party who pressed the
Push-to-talk key. Conversation flow is reversed
when the key is released. When both parties
have pressed the Push-to-talk key, the party
who pressed the button last is given
precedence to speak.