Group calls, Setting call receiving modes, Automatic connection – Toa N-8000 Series Ver.1.41 User Manual
Page 60: Continuous call, P. 2-8
2-8
Chapter 2: FUNCTIONS AND OPERATION
2.2.6. Group calls
• When a station is assigned to group call member station, if the station is called, this station (representative
station) and all member stations are simultaneously called by a continuous call tone regardless of their call
receiving mode settings.
• Even when the representative station is busy, all of the associated member stations within the same group
are called by means of a continuous call tone. This continuous call tone stops when any one of the
associated stations responds to the call.
Notes
• Use the supplied N-8000 Software program to perform the group call member station setting.
• The N-8050DS Door Station and N-8540DS IP Door Station cannot be assigned to the group call
representative station nor member station.
Call
Conversation
Station number where
group calls is set
Any key
Continuous call tone
X
X
X
Continuous call tone
Continuous call tone
2.3. Setting Call Receiving Modes
Call receiving modes, and call tone on/off can be selected for each station.
Use the supplied N-8000 Software program to perform the setting. (Refer to
2.3.1. Automatic connection
Incoming calls are automatically connected after a brief call tone (about 1 second) or without a call tone.
When a call is received, the status indicator flashes red. It lights red continuously when a conversation begins.
Lifting the handset creates a handset conversation.
2.3.2. Continuous call
Calls continue with a continuous call tone (or without a call tone) and a status indicator continuously flashes
as long as no response is made. When a call is received, the status indicator flashes red. It lights red
continuously when a conversation begins.
Lifting the handset to respond to a call creates a handset conversation.
Pressing any key to respond to a call creates a hands-free conversation (one-touch key response).
Note
The N-8050DS Door Station and N-8540DS IP Door Station cannot be set for the continuous call function.