Toa N-8000 Series Ver.1.41 - Manual (Page 144)

4-14
Chapter 4: BEFORE PERFORMING SYSTEM SETTINGS…
[Setting procedures]
Step 1. Using a system setting PC* 1 , set a network* 2 for Exchanges, Multi interface units, and IP stations that
permit broadcast communications with this PC.
*
1 PC (A) in the illustration on the previous page
* 2 LAN (A) in the illustration on the previous page
Use the supplied N-8000 software program's unit scan function to perform settings. (Refer to p. 5-10 .)
Step 2. Using the PC in each LAN, set the networks* 3 for Exchanges, Multi interface units, and IP stations
that cannot conduct broadcast communications with the system setting PC.
*
3 LANs (B) and (C) in the illustration on the previous page.
• Use the N-8000 software program's unit scan function to perform settings.
Note
Use the N-8000 software only for the network settings of Exchanges, Multi interface units, and IP
stations. When performing individual settings related to the general system, use the PC (A).
• One of the following two methods can also be used to perform settings (Refer to p. 6-5 .):
(1) Perform settings via a network using the PC's Web browser.
Note
If the system contains multiple Exchanges, Multi interface units, or IP stations, and their IP
address numbers are identical (factory-preset setting), connect each exchange to a network and
perform settings individually.
(2) Disconnect the Exchange, Multi interface units, or IP stations from the LAN to directly connect it
to the PC using a crossover LAN cable, then perform settings by way of the Web browser.
• Another method can also be used to perform settings on the menu screen of the multifunctional
master station without using a PC. To perform an exchange's network setting, connect the
multifunctional master station to the exchange to be set. For the IP multifunctional master station, its
network setting can be performed using its on-screen setting menu. (Refer to
p. 7-5 .)
Step 3. Set the system to allow communications from the system setting PC to all Exchanges, Multi interface
units, and IP stations on the network.
Using the N-8000 software's system setting function on the system setting PC, register the
Exchanges, Multi interface units, and IP stations of which network settings have been set in Step 1 or
2. (Refer to
p. 5-18 .)
These procedures permit communications between the system setting PC and all Exchanges, Multi
interface units, and IP stations within the system.