Toa N-8000 Series Ver.1.41 - Manual (Page 92)

2-40
Chapter 2: FUNCTIONS AND OPERATION
4.9. Remote Dial Control (only when the N-8000MI is used)
When the N-8000MI's contact input terminal is closed, a station is made to automatically perform dial
operation. A set of up to 20 dial codes (including dial numbers and key operations) can be assigned to each
contact input terminal.
For example, signals from a sensor can automatically activate a station to make a call as shown below.
Use the supplied N-8000 Software to perform settings for the Remote dial control. (Refer to
p. 5-42 .)
Note
To perform the remote dial control, the contact input terminal needs to be closed for over 50 ms.
[Example]
No. 200 station automatically calls the No.100 station by means of a make contact input to the N-8000MI from
a sensor.
No. 100 No. 200
Calls No. 100.
Remote control activation
N-8000MI
Sensor, etc.
Make contact
1 0 0
Call tone