Toa N-8000 Series Ver.1.41 - Manual (Page 130)

3-34
Chapter 3: INSTALLATION & WIRING
4.8. E-7000TB Terminal Board Wiring
For cable connection to the E-7000TB Terminal Board use the optional YC-105, clipping tool.
Hook the end of the cable onto the terminal and, with the cable end in hand, press the YC-105 Dedicated Tool
down onto the terminal from above. Pressing down the YC-105 tool cuts off the excess cable end, securing
the connection.
For cables, refer to p. 3-31 , Type of Cable.
Terminal board E-7000TB
Cut end
Cable
Hook the cable onto
the terminal without
stripping the cladding.
Terminal
Yellow Gray
Clipping tool YC-105 (Optional)
Bind the cables using cable
clips supplied with the E-7000TB.