Toa N-8000 Series Ver.1.41 - Manual (Page 146)

5-2
Chapter 5: SYSTEM SETTINGS BY SOFTWARE
1. N-8000 SOFTWARE GENERAL DESCRIPTION
1.1. General Description
The supplied N-8000 software program is for performing system settings and features following two functions.
1.1.1. Equipment scan and network setting functions
Detect the Exchange, Multi interface unit, and IP station connected to the local network, and then perform
equipment network settings. Use this software when performing initial setting.
Note
The equipment scan function can only be used within the effective broadcast range. Other equipment that is
not within this range must be set using a different network setting (Refer to
p.4-13 ).
1.1.2. System setting function
Performs individual settings related to system.
Note
This software does not display system operation logs, but these can be viewed using browser software
instead. (Refer to
p.6-17 .)
1.2. PC Network Settings
Perform PC network settings in advance according to your network administrator's instructions. Be sure to
verify these, since incorrect settings could adversely affect other equipment connected to the same network.
Note
Perform the PC's network setting to allow the PC to communicate with Exchanges, Multi interface units, and
IP stations.
N-8000 system settings cannot be performed unless the PC's network setting is completed.
However, even the PC of which network setting is not completed may perform the network setting for the
Exchange, Multi interface unit, and IP station.
1.3. Notes on Setting Update
To avoid equipment failures, never restart the Exchange, Multi interface unit, and IP station or switch off the
power while in the process of updating* settings.
* The Status indicator light will remain lit while updating is in progress.