Toa N-8000 Series Ver.1.41 - Manual (Page 82)

2-30
Chapter 2: FUNCTIONS AND OPERATION
Step 2. Manual Scan
2-1. Stopping and restarting automatic scan
To continuously monitor a specified station, press the [0] key when that station is displayed to stop
automatic scan operation. Pressing the [0] key again restores automatic scan operation.
2-2. Advancing a scan
Pressing the [ ] key advances the scan by one station.
2-3. Moving back a scan
Pressing the [ ] key moves the scan back one station.
2-4. Warning the monitored station by voice
To transmit a voice warning to the monitored station, press the Push-to-talk key.
Step 3. Scan Monitor end
To end Scan monitor, either press the Clear key or replace the handset.
4.2. PBX Connection (only when the N-8000MI is used)
If the Multi interface unit is connected to the PBX's analog E&M interface, calls or conversations can be
mutually made between the N-8000 system's stations and the PBX's extension telephones or paging calls can
be initiated from the PBX extension telephone.
4.2.1. Calling the PBX extension telephone
Step 1. Dial the analog E&M interface access number at a N-8000 system's station.
The station is connected to a PBX.
Step 2. Confirm that a dial tone from the PBX is heard, then dial the PBX extension number.
The extension telephone is called.
Note
Set the analog E&M interface access number using the supplied N-8000 software. (Refer to
p. 5-40 .)
Confirmation tone
Analog E&M interface
access No.
PBX extension No.
Call
Calling tone
Telephone
X
Y Y Y