Toa N-8000 Series Ver.1.41 - Manual (Page 166)

5-22
Chapter 5: SYSTEM SETTINGS BY SOFTWARE Chapter 5: SYSTEM SETTINGS BY SOFTWARE
General: Station Table
Pressing the Collective setup button permits station types, station numbers, and station names for all or
selected stations to be set all at once.
Step 1. Press the Collective setup button.
The Collective setup window appears.
Step 2. Select either "All stations" or "Selected stations" for the Setup range.
When "Selected stations" is selected, designate the setup range on the Station Table screen.
To do so, drug the mouse over the station list, or click stations one by one while holding down the
Shift key of the PC.
Step 3. To change the station type, tick the corresponding box and select the desired type from the pull-down
menu.
Note: Types of IP stations cannot be set collectively.
Step 4. To assign sequence station number, tick the corresponding box and enter the start number.
Example: When "100" is entered for a start number, the station numbers to be automatically set are
"100," "101," "102," and so on.
If a set station number comes to the maximum number in the set number digits, no further station
number is assigned.
Step 5. To change the station name with sequence number, tick the corresponding box and enter a new
name.
Up to eight alphanumeric characters including the sequence number can be used.
Example: When a station name "stat1-" is entered, the station names to be automatically set are
"sta1-1," "sta1-2," "sta1-3," and so on.
Step 6. Press the OK button.
(6) Station name
Set the name of each station using up to eight alphanumeric characters. Station names can be displayed
on multifunctional stations.
[Collective setup]
3
2
4
5
1