Toa N-8000 Series Ver.1.41 - Manual (Page 244)

7-5
Chapter 7: MULTIFUNCTIONAL STATION MENU SCREEN OPERATION (N-8000MS /8500MS ONLY)
1 : N e t w o r k s e t
2 : L i n e A t t r i b u t e
I P A d d r e s s
1 9 2 . 1 6 8 . 0 0 1 . 1 2 8
S u b n e t m a s k
2 5 5 . 2 5 5 . 2 5 5 . 0 0 0
S u b n e t m a s k
2 5 5 . 2 5 5 . 0 0 0 . 0 0 0
D e f a u l t g a t e w a y
1 9 2 . 1 6 8 . 0 0 1 . 2 5 4
D a f a u l t g a t e w a y
1 9 2 . 1 6 8 . 2 5 4 . 0 0 1
I P A d d r e s s
1 9 2 . 1 6 8 . 0 0 5 . 0 6 4
1 : N e t w o r k s e t
2 : L i n e A t t r i b u t e
1 0 : 0 8 A M
2 0 0 0
X
X
X
6.2. Network Settings
It is possible to change the IP address, subnet mask, and default gateway of the exchange or N-8500MS*.
* Exchange when the station performing setting is N-8000MS, and the N-8500MS itself when it is the N-8500MS.
Step 1. Using the up or down arrow keys or the [1] key on
the maintenance screen, move the cursor to "1:
Network set."
Step 2. Press the Select key to display the IP address of the
exchange to which the station is connected or of the
N-8500MS.
Step 3. Using the dial keys, enter the desired IP address,
then press the Select key. When not changing the IP
address, press the Select key only.
The subnet mask of the exchange or N-8500MS is
displayed.
• The periods (.) within the IP address need not be
entered. Enter numerals consecutively.
• If a number separated by a period is a single or
double digit number, add the prefix [0] or [00] to
make them 3-digit numbers. For example, enter the
IP address "192.168.5.64" as "192168005064."
Step 4. Using the dial keys, enter the desired subnet mask,
then press the Select key. When not changing the
subnet mask, press the Select key only.
The default gateway of the exchange or N-8500MS
is displayed.
Note
For entering figures, follow the same process as
Step 3.
Step 5. Using the dial keys, enter the desired default
gateway, then press the Select key. When not
changing the default gateway, press the Select key
only.
The screen reverts to the system setting item
selection display, completing the change in network
settings.
Note
For entering figures, follow the same process as
Step 3.
Step 6. Press the Menu key to return the display to its
normal standby mode.
Note
Network settings are not immediately updated, but must be made effective by restarting the exchange or N-
8500MS.
To restart the exchange, press the Reset key located on the front panel of the exchange or use the exchange
reset screen (refer to
p. 7-8 ).
To restart the N-8500MS, use the exchange reset screen (refer to p. 7-8 ).