Toa N-8000 Series Ver.1.41 - Manual (Page 193)

5-49
Chapter 5: SYSTEM SETTINGS BY SOFTWARE Chapter 5: SYSTEM SETTINGS BY SOFTWARE
IP Station: Function Settings 1
5.6.2. Function settings
Step 1. Click "Function Settings 1" tab to display the following setting screen.
Available item differs depending on the type of IP stations.
Step 2. Set individual items.
(1) Transfer settings (IP master station only)
Set the transfer function ON or OFF.
Call forwarding: Calls to stations are automatically transferred to another designated
station without sounding a call tone only when Call forwarding function is
enabled.
Time-based call forwarding: Calls to stations are automatically transferred to another designated
station without sounding a call tone only when the preset time is reached.
Preset time can be set only when the time-based call forwarding function is
enabled.
Group hunting: Calls to a busy station are automatically transferred to another designated
station, if group hunting function is set to the called station.
Absence transfer: When no response is made to a call to the station for a set period of time,
the call is automatically transferred to another designated station. Preset
time duration can be set only when the absence transfer mode is enabled.
(2) Oneshot make time (second)
Sets the duration that the external control output terminals are shorted momentarily when the door remote
control function is performed.
The setting range is from 0 to 9 (in 1-second units).
If not required, set the duration to "0."